코엔원

• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Darken the steering wheel, wheel wells, side moldings, the air dam under the front bumper, and inside of the window. Step 5: Add the top of the steering wheel and the stick shift that sits on the steering wheel column. Step 4: Form the headlights, grille, and rubber molding on the front bumper by drawing many straight lines and a few curved ones. Show the positions of the front bumper, grille, headlights, and front hood with straight and curved lines.

For the rear bumper, draw a short curved line. Under the front bumper, place an air dam that looks like a check mark lying on its side. For the wheel well above each tire, sketch an object that looks like an upside-down bowl. Step 3: To form the wheel wells, sketch a half circle with one end that curves out around the top of each tire. Step 3: To form the driver’s-side window, sketch a rectangle with a slanted left side that is drawn around an odd-shaped oval (the sideview mirror).

Step 2: Inside each tire, sketch a small oval in a larger oval for the hubcap. Above the long rectangle, sketch a rectangle with slanted sides for the driver’s-side windows.

From the front of the truck to the back, add side moldings by drawing two straight lines, one above the other. Add the bullet-shaped sideview mirror. Connect the sideview mirror to the door with a sharply curved line. Place a curved line above each wheel for the fender.

For the gas cap, draw a small circle between the door and the rear wheel. Draw a figure shaped like a thick dark staple inside of the taillight. To the rear wheel, connect a backward L-shaped figure (for the bottom and rear portion of the pickup truck) with a cuplike bumper attached. Add a very short line to the top and bottom of the windshield, forming a long skinny triangle. Place a short straight line inside the rear bumper.

For the lower side moldings, draw one long straight line and a short one along the side and the rear panel. Step 1: Draw a long rectangle for the driver’s side of the body with two overlapping circles on the right and left ends for the wheels. To the lower right side, attach a large U-shaped figure lying on its side. You just need the right cable to make the connection. It can also hit 0 to 60 in about 4.4 seconds if you need some hybrid speed.

You can learn how to draw this pickup truck by following our steps below.

Now that you can draw a pickup truck, why not go for At&T Finance Internship something larger? They can now be launched in 15 mile (24 kilometer) per hour winds, and the work that used to take 14 people and 45 minutes now takes 4 people and 15 minutes.